FiltraPac Operator's Manual READ THIS BOOK This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Clarke machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it.
Table of Contents Operator Safety Instructions ............................................................................................................ 3 Safety Information ........................................................................................................................... 4 Introduction & Machine Specifications ............................................................................................ 5 Grounding Instructions ....................................................
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should be followed including the following: Read all instructions before using these appliances WARNING AVERTISSEMENT ADVERTENCIA DANGER: Failure to read and observe all DANGER statements could result in severe bodily injury or death. Read and observe all DANGER statements found in your Owner's Manual and on your machine.
SAFETY INFORMATION Information for your safety and notes on disposal Before using the FiltraPac, please read the information below with care. This gives important guidance on the safety use and maintenance of the FiltraPac. Keep this booklet in a safe place, and if appropriate, hand it on to the next owner. • This Clarke vacuum complies with recognized technological standards and the current safety regulations for electrical appliances.
INTRODUCTION MACHINE SPECIFICATIONS Model Power Supply Vacuum Motor Power Brush Motor Cord Wand Attachment Hose Filter Bags Weight Shipping Weight Warranty Filtra-Pac 02150A 115V-60 Cycle 19,200 rpm 11,000 rpm 40 ft. 1 3/8" x 20 1/2" (2) 1 1/4" x 64" 6 lt, 2-ply disposable 11.5 lbs. 17 lbs 1 year The FiltraPac is a vacuum for cleaning carpet. This machine is used to remove dry material from carpet. This machine is intended for commercial use. OPTIONAL ACCESSORIES Part No.
GROUNDING INSTRUCTIONS This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
MAINTENANCE WARNING: To prevent injury, always remove the electrical plug from the electrical outlet before doing any maintenance or repairs to the machine. WARNING: Maintenance and repairs must be done by authorized personnel only. Use only genuine Clarke parts. How To Change The Filter Bag The machine uses a paper filter bag or a cloth filter bag. To change the paper filter bag, follow this procedure: Figure 3 1. Make sure the ON/OFF switch in the "O" position. 2. Open the front of the tank housing.
MAINTENANCE How To Clean The Motor Filter Clean the motor filter whenever it is dirty. To clean the motor filter, follow this procedure: 1. Open the tank assembly. 2. Remove the filter bag. 3. Pull the filter cover off the filter disc. 4. Remove the filter. Figure 6 5. Wash the filter in water. 6. Put the filter in a cloth and apply pressure to dry the filter. 7. Put the filter in the filter cover. NOTE: Install the filter cover with the opening toward the back of the tank housing. See figure 6.
FiltraPac Section II Parts and Service Manual (70290A) Clarke® FiltraPac Operator's Manual Page 9
Clarke® FiltraPac Main Body Assembly Drawing 7/01 1 2 3 13 14 15 16 17 6 18 19 20 4 5 6 7 21 8 6 23 9 10 24 11 25 12 26 27 21 28 29 31 32 33 34 35 36 6 37 38 30 Page 10 Clarke® FiltraPac Operator's Manual
Clarke® FiltraPac Main Body Assembly Drawing Parts List 1/05 Ref. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 NI Part # Description 52370A 52371A 52372A 52373A 52374A 57951A 52375A 964004 52376A 52377A 52378A 52379A 80067A 52380A 55658A 58693A 52381A 53408A 55715B 52906B 50636A Power Cord only Switch only Power Cord w/Switch Cover Washer Strain Relief Screw 4mm x 20 Washer Screw, 5mm x .
Clarke® FiltraPac Back Frame and Harness Assembly Drawing and Parts List 7/01 50 51 52 53 54 55 56 Ref. Part # 50 51 52 53 54 55 56 Page 12 52387A 52388A 52389A 52390A 980205 52391A 52394A Description Carry Frame Complete Carry Frame Shoulder Strap Rivet Washer Waist Belt Rivet Nut Qty.
Clarke® FiltraPac Hose, Wand and Tools Assembly Drawing Parts List 1/05 65 66 68 69 60 61 62 63 64 70 71 Ref. Part # Description 60 61 62 63 Crevice Tool Wand - 2 Piece Nozzle Upholstery Soft Floor Tool Hard Floor Tool Bristle Set Regulating Slide Hand Tube Connecting Socket Hose & Handle Asm. Swivel End, Hose Retainer, Spring Socket, Connecting 64 65 66 68 69 70 71 72 59203A 54490 59204A 59206A 59978A 52395A 52478A 61447A 52479A 10372A 53054A 57405A 53075A 72 Qty.
Clarke® FiltraPac Electrical Schematic 11/04 Page 14 Clarke® FiltraPac Operator's Manual
CLARKE PRODUCT SUPPORT BRANCHES U. S. A.
Clarke® U.S. LIMITED WARRANTY This Clarke Industrial/Commercial Product is warranted to be free from defects in materials and workmanship under normal use and service for a period of one year from the date of purchase, when operated and maintained in accordance with Clarke’s Maintenance and Operations Instructions. This warranty is extended only to the original purchaser for use of the product. It does not cover normal wear parts such as electrical cable, rubber parts, hoses and motor brushes.
