Operator`s manual

ManualsBrandsClarke ManualsHousehold AppliancesIMAGE 14 120V

Page 14 CLARKE TECHNOLOGY Image 20 Operator's Manual

THE CONTROLS

The Vacuum/Accessory Switch

This switch is located on the left side of the control

panel. To turn the vacuum motor and pump motor on,

press the bottom of the switch. To turn the vacuum

motor and pump motor off, press the top of the

switch.

The Spray/Brush Motor Switch

The spray/brush switch is located in the center of the

control handle. To turn on the spray/brush intermit-

tently, press the top of the switch and hold for the

length of time you want the floor spray/brush to run.

To turn on the spray/brush continuously, press the

bottom of the switch. To turn the spray/brush off,

press the center of the switch.

NOTE: The vacuum/accessory switch must be in the

"I" position before spray will work.

The Vacuum Hose Connector

The vacuum hose connector is on the center right

hand rear of the machine.

The Solution Hose Connector

The solution hose connector is located in the center

in the rear of the machine. This connection is used

to hook up optional auxiliary floor tools.

Recovery Tank Drain

Remove hose from rear of machine. Place over drain

and open valve.

Solution Tank Drain

Remove the hose from the rear of the machine. Place

over drain.

Brush Adjustment

Adjustment is located to the front right side of the

machine. Pull spring loaded pin and place in se-

lected slot. If breaker trips, move adjustment one slot

higher.

Variable Pump Pressure (ix model only)

The control knob is located on the right side of the

control panel. The knob is divided into three operating

ranges; upholstery, interex and restoration. These

range settings are only suggested starting points.

The control knob can be adjusted clockwise to

increase flow and pressure or counter clockwise to

decrease flow and pressure. If streaking occurs,

increase pressure setting.

Upholstery Setting: Used for accessory tools.

Interex Setting: Used with interim brush for

light extraction at medium

flow and pressure.

Restoration Setting: Used with restoration

brush for deep extraction

at high flow and pressure.