Specifications

12
STOPPING THE POWER WASHER
1.
Fig. 10
Release the gun trigger (A) Fig. 10
2. Set the Hot / Cold selector switch
(I / 0/II) to (0), to stop the power
washer
3.
When the power washer has
stopped, pull the trigger (A) a few
times to discharge any residual
pressure left in the hose.
4.
Fig. 11
Engage the safety catch (B) of
the gun trigger. See Fig. 11.
APPLYING CHEMICALS AND CLEANING AGENTS
1.
Fig. 12
Take hold of the gun in one hand.
2. Fill the detergent bottle with
suitable power washer dete
rgent
available from your Clarke dealer.
3. Fit the detergent bottle onto the
gun as shown in Fig. 12
4. Tighten the collar to secure.
5. After use, rinse the detergent
bo
ttle thouroughly.
SHUTTING DOWN
1. Place the three-position switch to (0) to turn the power washer off.
NOTE: NEVER turn the water off wi
th the pump running.
2. Turn water supply off.
3. Pull trigger on spray gun to relieve any
water pressure.
4. See page
13. in this manual for proper storage procedures.