Shown with optional Hose Reel OPERATING & MAINTENANCE INSTRUCTIONS 0704
SPECIFICATIONS Motor .............................................................. 230V 50hz Power Rating .................................................. 1.6kW Fuse Rating ..................................................... 13Amps Max. Pump Pressure ...................................... 110bar Hot Wash Operating Temp. .......................... 70Oc Water Flow Rate ............................................. 6.0 L/min Fuel Capacity ................................................ 4.
TROUBLE SHOOTING FAULT Pressure drop CAUSE REMEDY Air in system Bleed system by quickly switching off pistol grip several times. If necessary operate the machine briefly without the high pressure hose connected. Worn high pressure nozzle.
SAFETY PRECAUTIONS PARTS DIAGRAM WARNING Water at high pressure can be dangerous and may cause severe damage to persons or property if subject to misuse. NEVER allow anyone to operate this equipment unless they are thoroughly reliable and completely familiar with the safety precautions. 1. Never direct the spray jet at any person or animal. 2. Never hold a finger over the high pressure nozzle. 3. Never direct the spray jet at the machine itself or any other electrical equipment. 4.
14. Disconnect from the mains supply before carrying out any maintenance or servicing.
ELECTRICAL CONNECTIONS WARNING: THIS MACHINE MUST BE EARTHED. This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a standard, domestic electrical supply. Should the plug need changing at any time, ensure that a plug of identical specification is used. IMPORTANT: The wires in the mains lead should be wired up in accordance with the following colour code: Green & Yellow ................ Earth Blue .................................... Neutral Brown ................
TURBO NOZZLE Fig.8. A Lance provided with a Turbo Nozzle is also supplied see Fig.8. Carefully remove the washer and loose parts from the packing and check to ensure that no damage was incurred during transit. Should damage be apparent, please contact your Clarke dealer immediately. This nozzle has the effect of increasing the pressure at the nozzle, and producing a swirling, conical jet, which is ideal for patio cleaning etc.
Fig.4. NOTE: OPERATION A. COLD WASH The high pressure hose is secured to the handle by means of a latch shown in Fig.4. ON-OFF switch Fig.6. Make certain the PUMP ON/OFF switch mounted on right front of the unit, is set in the ‘O’ - OFF position. To remove the hose, prise the latch down, to the position shown, and pull out the hose. Connect the plug to the mains supply, preferably via a Residual Current Device. Turn the water tap fully on. Fig.5. 3.
