PATIO HEATER MODEL No.
Thank you for purchasing this CLARKE PATIO HEATER. WARNING! It is MOST IMPORTANT that ANYONE attempting to use this apparatus read this booklet thoroughly beforehand and carefully follow the instructions given. This will ensure their safety, and that of others around them. Additionally, you can look forward to the heater giving you long and satisfactory service.
FEATURES Patio Heaters are portable radiators, simple, highly efficient and reliable, whose functions are based on the principle of reflected heat. Wide areas can be heated depending upon atmospheric conditions. These models can be used outdoors or indoors if the room is large enough and has a constant supply of fresh air. Patio Heaters are suitable for an environment with a volume of at least 200 m3 Patio Heaters do not expel exhaust gas, non-polluting liquid gas fuel is used (Propane).
SAFETY PRECAUTIONS This Patio Heater is designed for OUTDOOR USE ONLY • Patio Heaters MUST NOT be used in homes, offices and similar environments. • NEVER MAKE ANY MODIFICATIONS to the heater.
ASSEMBLY 1 2 Carefully unpack the components and lay them out, checking to ensure that no damage was suffered in transit. Should any damage be apparent, you should contact you Clarke dealer immediately. 3 Ensure the nuts on the top of the diffuser are tight. Attach the Diffuser to the Burner assembly.
4 6 5 Attach Support Brackets to Stack Support. Attach Base to the three support brackets. 6xBolts M6x20 6xBolts M6x20 12xFlat Washers 12 Flat Washers 6xLock Washers 6xLock Washers 6xM6 Nuts 6xM6 Nuts 7 Attach stack to the stack support.
8 Lower Top Cover over Stack 9 Attach Gas Delivery Pipe to the Burner Assembly, ensuring it is perfectly tight. NOTE: USE TWO SPANNERS AS SHOWN. NOTE: Test the joint for leaks by applying a soapy liquid to the joint. If bubbles appear, tighten the nut. The joint must be gas tight. 10 11 Insert Gas Delivery Pipe into Stack Secure Burner Assembly to Stack.
12 13 Attach Reflector by placing two flat washers on each post followed by the reflector, then the round headed nuts. Attach the regulator hose to the connection arrowed, using the worm drive clip supplied, ensuring the connection is perfectly tight. NOTE: The hose should be approx. 40cm in length. 14 Slide the front panel into place. NOTE: Check the Regulator and hose for leaks by applying a few drops of soapy liquid to the joints.
OPERATION WARNING! Before using your Patio Heater ensure that all safety precautions have been complied with. A. Connecting the Gas Bottle Fig.1 1. Ensure the Burner Control Knob (A, Fig.1) is in the OFF position. To do this, push the knob IN and turn fully CLOCKWISE. 2. Remove the access panel and check condition of the regulator and hose. 3. Place the cylinder in its compartment. 4.
STORAGE The heater is constructed from materials to withstand normal weather conditions, however, it is advised to store under cover for maximum preservation. If there are problems of space, the reflecting hood (1) can be removed, and the nuts and washers preserved with care (NB: they are all stainless steel). Remove the cylinder from its compartment. Enclose the burner unit in a polythene bag and similarly wrap the side covers to discourage the possibility of local wild life from setting up home.
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE REMEDY Gas odour during setup Gas leak Check all gas connections Gas odour before first ignition Gas leak Check all gas connections When piezo igniter button is pressed, there is no spark at pilot electrode.
