Instruction manual

SET UP

NOTE: Use good quality alkaline batteries and avoid rechargeable

batteries.

1. Have the indoor weather station and remote temperature sensor close

together during setup.

2. Place the batteries into the remote sensor first then into the weather

station. See below.

INSTALLING THE BATTERIES

REMOTE SENSOR (FIG 1)

Battery compartment retaining screw

Fig 1

Unscrew and remove the battery

compartment retaining screw.

2. Remove the battery

compartment cover.

Insert two alkaline AAA batteries

into the remote sensor.

NOTE: Make

sure that you follow

the polarity diagram inside

the battery compartment.

4. Replace the battery compartment cover.

INDOOR BASE STATION (FIG 2)

Fig 2

Remove the battery cover.

2. Observing the correct polarity,

install three alkaline AA batteries.

Replace the battery cover.

4. Do not press any buttons for at

least ten minutes

This will allow

time for the weather station to

start receiving information from

the sensor,

• If successful the indoor weather station will show the outdoor

temperature and humidity.