AIR NAIL GUN MODEL: CNG1C Part No.
SPECIFICATIONS Min. Hose Size (ID) ........................................................................ 6mm (1/4”) Air Inlet Connector ....................................................................... 10mm Quick Fit Ave. Air Consumption .................................................................. 0.47 cfm Operating Pressure ....................................................................... 4 - 7bar (60-100psi) Air Pressure Max ............................................................
Please read these instructions carefully before operating the tool Thank you for purchasing this CLARKE Air Nail Gun Before using the device, please read this leaflet thoroughly and carefully follow the instructions given. In doing so you will ensure the safety of yourself and that of others around you, and you can also look forward it giving long and satisfactory service. GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase.
SAFETY PRECAUTIONS IMPORTANT Failure to follow these precautions could result in personal injury, and/or damage to property. 1. When operating this tool, ALWAYS wear: a. approved impact resistant SAFETY GOGGLES. (Eye glasses are NOT safety glasses) b. EAR DEFENDERS c. a good pair of INDUSTRIAL GLOVES 2. ALWAYS disconnect the tool from the air supply when not in use, and before carrying out any maintenance 3. ALWAYS keep a safe distance between yourself and others when using the tool. 4.
AIR SUPPLY WARNING! Compressed air can be dangerous. Ensure that you are thoroughly familiar with all precautions relating to the use of compressors and compressed air supply. Tools of this type, operate on a wide range of air pressures. It is recommended that air pressure be set to between 60 and 100psi. at the tool when running. Higher pressure and unclean air will shorten the tools’ life and could be a safety hazard.
MAINTENANCE Daily before use. 1. Drain water from compressor air tank, and air line. 2. Check and clean, if fitted, the air inlet gauze filter. 3. A bottle of CLARKE Air Line Oil** is supplied with the kit. Squirt a few drops of oil (approx. 3cc), into the air inlet. This should be carried out regardless of whether or not an air line lubricator is used. During Use.
ACCESSORIES A wide range of Airline accessories is available, including Filter/Regulators. Lubricators, High Pressure Hoses from 5 to 100 Metres, Whip hose etc. Contact your CLARKE dealer for further information, or CLARKE International Sales Department on 01992 565333 CONSUMABLES 1.25mm Crown 15 20 25 30 32 18 GAUGE 35 40 45 50 Nails - 18 Gauge - 1.25mm Crown Length Part No: 15mm ................................ 1800413 20mm ................................ 1800415 30mm .............................
PARTS DIAGRAM 8
PARTS LIST No. Description 1 Hex Skt. Hd. Bolt No. Description Part No. Part No. HTCNG1C01 33 Bearing Plate HTCNG1C33 2 Deflector Spring HTCNG1C02 34 Pin 2.5x16 HTCNG1C34 3 Air Deflector HTCNG1C03 35 Bracket HTCNG1C35 4 Bolt M5x50 HTCNG1C04 36 Pusher Spring HTCNG1C36 5 Spring Washer HTCNG1C05 37 Safety Element HTCNG1C37 6 Cylinder Head HTCNG1C06 38 Spacer HTCNG1C38 7 O-Ring 3.7x2.
RECOMMENDED AIR SUPPLY CONNECTION DECLARATION OF CONFORMITY We declare that these products comply to the following standards/directives • Model No: Serial or Batch number: BS EN 792-13: 2000 CNG1C See product data plate signature: L. E. Fergusson SERVICE MANAGER SPARE PARTS & SERVICING CONTACTS For Spare Parts and Service, please contact your nearest dealer, or CLARKE International, on one of the following numbers.
