User's Manual

English

Note: If alarms 1 and 2 are set for thesame time alarm 2 will override alarm 1 and also

if alarm 1 is in snooze mode. Alarm 1 will then be switched off and won’t go off again for

another 24 hours. The second alarm is then theone that will be active and will sound.

Display illumination

Press [ ] to change thestrength of thedisplay illumination, high/low.

Note: The display illumination level cannot be changed when theradio is on or when

thealarm is going off.

Nap feature

1. Press [ NAP▲ ], when thedisplay shows and “n05” begins to ﬂash.

2. Press [ NAP▲ ] to set thenap duration time: 5, 15, 30, 45, 60, 75 or 90 minutes.

Input thedesired time and wait afew seconds until thedisplay resumes normal

time display and is shown on thedisplay, which indicates that thenap function

is now activated.

3. The alarm will sound once theset time is reached. Press [ NAP▲ ] to turn off

thealarm and thenap function. will disappear from thedisplay.

Note: If any of theother alarms sound during theset nap time, thenap function will

then be cancelled.

Radio

1. Extend theFM aerial to its full length and turn on theradio by pressing [ RADIO/SL ].

The current radio station frequency will then be displayed.

2. Press [ ▲ ] or [ ▼ ] in order to set thedesired station or hold in [ ▲ ] or [ ▼ ] in order

to automatically search upwards through thefrequency band for thenext station.

3. Press [ VOL ] to adjust thevolume. “L07” will appear on thedisplay. Press [ ▲ ] to

increase and [ ▼ ] to decrease thevolume.

4. Press [ ] to turn off theradio.

Note: If reception is poor, try changing the position of the aerial or the clock radio.

Saving radio station presets

There are 10 preset memory slots available.

1. Turn on theradio and set it to adesired station.

2. Hold in [ SET ] until “MEM” appears and “01” begins ﬂashing.

3. Press [ SET ] to save thestation to memory slot 1.

4. Press or hold in [ ▲ ] or [ ▼ ] to search for thenext desired station.

5. Hold in [ SET ] until “MEM” appears and “01” begins ﬂashing.

6. Press [ ▲ ] or [ ▼ ] to search for thenext station for memory slot 2.

7. Press [ SET ] to save thestation to memory slot 2.

8. Repeat theabove procedure to save stations to theother memory slots.