Instruction Manual

FORM-ENG-0018 REV A 05-27-03
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : [phone] or 1-800-520-3473
TECHNICAL DATA SHEET
PAGE
15 OF 26
DATE
3/28/2012
PRODUCT GROUP
THROTTLE CONTROL
P/N 117155 REV
1.23
PRODUCT
TOTAL PRESSURE GOVERNOR (TPG)
BY AMS
Manual P/N 117684
MENU ITEM DESCRIPTION DEFAULT MENU LEVEL
XDCR
Configures transducer type (300 or 600 psi) (300 default)
300
3
FACTORY DFLT
Returns all menu parameters to the factory default state
(Cummins Control – message type CFPG)
N/A
3
* Option dependent on other menu selections made
Menu items in menu level 4
MENU ITEM DESCRIPTION DEFAULT MENU LEVEL
POC ASSERT
Configures when idle offset is asserted (with power on cycle or mode
switch)
(Only available with message type ANLG)
NO
4*
GOV GAIN
Configures the RPM change requested per INC or DEC switch press
(Only available with message type ANLG)
15
4*
PRESS GAIN
Configures the pressure change requested per INC or DEC switch
press
3 PSI
4
DITHER
Configure the engine handshake
(Only available with message type PGN0)
NO
4*
LAG (∆PSI)
Controls the response of the pressure increase when the INC button
is held while in pressure mode.
5 PSI
4*
PUMP HOURS
Set/reset the number of pump hours
N/A
4
BCM1 VER
Configures the Scania BCM version
(Only available with message type SCAN)
1
4*
SCANIA MODE
Configures the Scania engine control type: NORMAL or STIFF
(Only available with message type SCAN)
NORMAL
4*
IDLE STEPS
Configures the idle offset voltage for analog control mode
(Only available with message type ANLG)
32
4*
* Option dependent on other menu selections made
Menu items in menu level 5
MENU ITEM DESCRIPTION DEFAULT MENU LEVEL
OK2PUMP
Configure the “okay to pump” interlock source
NORM
5
SPN 3350
Configure the PGN0 control purpose
(only available with message type PGN0)
P32
5*
SPN 696
Configure the Engine Requested Speed Control Condition
(only available with message type PGN0)
3
5*
HIDLE MODE
Configure the high idle mode
1
5
BUS INTLKS
Configure the bus interlocks
N
5
VOLTS
Calibrate the battery voltage display (+0.0 to +0.5 volts)
+0.0 volts
5
SMOOTHING
Configure pressure averaging (smoothing – NO, LO, HI)
LO
5
ENGINE ID
Configure the CAN source ID where the TPG receives its engine
information from. Normally this will always be address 0 unless
some kind of interface module is used between the engine and TPG
0
5
* Option dependent on other menu selections made