User Manual

FORM-ENG-0018 REV A 05-27-03
PAGE
2 OF 30
TECHNICAL DATA SHEET
DATE 4/9/2009
PRODUCT GROUP
THROTTLE CONTROL
P/N 118710 REV 1.00
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : [phone] or 1-800-520-3473
PRODUCT
TOTAL PRESSURE GOVERNOR PLUS (TPG+)
BY AMS
Manual P/N 118711
5.2.11. SENSOR CAL (pressure sensor calibration) .............................................................................. 21
5.2.12. 1
st
MODE (first active mode configuration) .................................................................................21
5.2.13. COMM STATUS (view the CAN communication status) ............................................................ 21
5.2.14. CONTROL (engine control message type) ................................................................................. 21
5.2.15. AUTO MODE (pressure mode automatically entered on pump engagement) ........................... 21
5.2.16. IDLE STEPS ............................................................................................................................... 22
5.2.17. IDLE RPM ................................................................................................................................... 22
5.2.18. MAXIMUM RPM.......................................................................................................................... 22
5.2.19. SourceID (CAN message source identification).......................................................................... 22
5.2.20. PSI TIME-OUT (pressure time out)............................................................................................. 22
5.2.21. ALLOW PRESET (allow RPM preset use when pressure is detected) ...................................... 22
5.2.22. WARNINGS (data monitor warning configuration) ..................................................................... 23
A. WARN ºF (User defined engine temperature high warning - Yellow LED)...................................................... 23
B. CRIT ºF (User defined engine temperature high critical - Red LED) .............................................................. 23
C. WARN PSI (User defined oil pressure low warning - Yellow LED) ................................................................. 23
D. CRIT PSI (User defined oil pressure low critical - Red LED) .......................................................................... 23
5.2.23. XDUCR (discharge pressure transducer range) ......................................................................... 23
5.2.24. FACTORY DFLT (Set factory defaults)....................................................................................... 23
5.2.25. GOV GAIN (RPM change per step) ............................................................................................ 23
5.2.26. PRESS GAIN (PSI change per step) .......................................................................................... 23
5.2.27. DITHER (Engine handshake)...................................................................................................... 23
5.2.28. LAG ∆PSI (Pressure lag) ............................................................................................................ 24
5.2.29. PUMP HOURS............................................................................................................................ 24
5.2.30. BCM1 VER (Body Control Message 1 version) .......................................................................... 24
5.2.31. SCANIA MODE? (Scania governor type) ...................................................................................24
6. CONFIGURATION ..................................................................................................................................... 25
6.1. CONFIGURE THE UNIT OF MEASURE .........................................................................................................25
6.2. SELECT PRESSURE TRANSDUCER RANGE: 300 PSI (DEFAULT) OR 600 PSI ...............................................25
6.3. ZERO CALIBRATE THE INTAKE AND DISCHARGE PRESSURE TRANSDUCERS .................................................26
6.4. CONFIGURE THE ENGINE CONTROL METHOD ............................................................................................26
6.5. CONFIGURE THE IDLE VOLTAGE AND GAIN SETTING USING AUTO SCALE ................................................. 27
7. MOUNTING & INSTALLATION.................................................................................................................28
7.1. PANEL CUTOUT DIMENSIONS ...................................................................................................................28
8. CONNECTOR DESCRIPTION................................................................................................................... 29
8.1. TPG+ CONNECTORS ..............................................................................................................................29
8.2. PRESSURE SENSOR CONNECTOR ............................................................................................................29
9. TECHNICAL DETAILS .............................................................................................................................. 30