User Manual

FORM-ENG-0018 REV A 05-27-03
PAGE
29 OF 30
TECHNICAL DATA SHEET
DATE 4/9/2009
PRODUCT GROUP
THROTTLE CONTROL
P/N 118710 REV 1.00
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : [phone] or 1-800-520-3473
PRODUCT
TOTAL PRESSURE GOVERNOR PLUS (TPG+)
BY AMS
Manual P/N 118711
8. Connector Description
8.1. TPG+ connectors
The module has two connectors and the following definitions apply:
Mating connector: Deutsch DT06-12SB BLACK
Mating sockets: Deutsch 0462-201-16141
Gold mating sockets: Deutsch 0462-201-1631
Wedge lock: W12S Recommended wire gage: 16-20 AWG
PIN CIRCUIT DESCRIPTION
1 SUPPLY (+) (INPUT) – battery voltage (+9VDC…+32VDC)
2 CAN HIGH (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s *
3 CAN SHIELD (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s *
4 ---- ----
5 Sensor GND (OUTPUT) – Intake pressure ground
6 Sensor REF (OUTPUT) – Intake pressure supply (+5VDC)
7 Sensor SIGNAL (INPUT) – Intake pressure signal (+0.5VDC to +4.5VDC)
8 ---- ----
9 ---- ----
10 ALARM (-) (OUTPUT) – alarm active (ground polarity, 250mA)
11 CAN LOW (DATA) – SAE J1939 CAN 2.0B, 250Kbits/s *
12 SUPPLY (-) (INPUT) – battery ground
* Gold sockets recommended for CAN connections.
Mating connector: Deutsch DT06-12SA GRAY
Mating sockets: Deutsch 0462-201-16141
Wedge lock: W12S Recommended wire gage: 16-20 AWG
PIN CIRCUIT DESCRIPTION
1 ENG REF (+) (INPUT) – analog signal reference (+5VDC) *
2 THROT INTLK (INPUT) – throttle ready interlock (positive polarity)
3 HI IDLE (INPUT) – high idle enable (positive polarity)
4 ---- ----
5 Sensor GND (OUTPUT) – Discharge pressure ground
6 Sensor REF (OUTPUT) – Discharge pressure supply (+5VDC)
7 Sensor SIGNAL (INPUT) – Discharge pressure signal (+0.5VDC to +4.5VDC)
8 ENG SIGNAL (OUTPUT) – analog signal control (+0.5VDC to +4.5VDC) *
9 ENG REF (-) (INPUT) – analog signal reference (ground) *
10 PUMP INTLK (INPUT) – pump engaged interlock (positive polarity)
12 RELAY COM (INPUT) – remote throttle reference (ground polarity) *
12 RELAY N.O. (OUTPUT) – remote throttle activate (ground polarity) *
* These pins and wires are available with the analog signal harness (p/n 117683)
8.2. Pressure sensor connector
The pressure sensors (intake and discharge) have one connector and the following definitions apply:
Mating connector: Packard 12078090
Mating sockets: Packard 12089290
Recommended wire gage: 16-20 AWG
PIN CIRCUIT DESCRIPTION
A SUPPLY (-) (INPUT) – pressure sensor ground
B SUPPLY (+) (INPUT) – pressure sensor supply (+5VDC)
C Signal (OUTPUT) – pressure sensor signal (+0.5VDC to +4.5VDC)