Owner manual

ManualsBrandsClass1 ManualsCarDigital Tank Level Display

page 1 of 5 pages

Engineering

Standards

Name Tank Level Display

Identifier Installation Information

Engineering Standard Number

C1-102245-A

Installation

The display mounts in a 2.84” by 1.51” cutout.

Overall area necessary for installation is 3.2” by 2.5”.

Two 0.201d holes are provided for mounting screws.

2.840"

.277

1.510

.470 1.900

Ø 0.201"

(2) HOLES

0.496"

0.612"

3.125"

0.142"

0.182"0.182"

0.285" 3.832"

Summary of content (5 pages)

PAGE 1
Engineering Standards Name Tank Level Display Identifier Installation Information Engineering Standard Number C1-102245-A Installation The display mounts in a 2.84” by 1.51” cutout. Overall area necessary for installation is 3.2” by 2.5”. Two 0.201d holes are provided for mounting screws. 2.840" 1.510 .277 Ø 0.201" (2) HOLES .470 1.900 0.496" 0.612" 3.125" 0.142" 0.182" 0.142" 0.182" 0.285" 3.
PAGE 2
Engineering Standards Name Tank Level Display Identifier Installation Information Engineering Standard Number C1-102245-A Tank Level Gauge Transducer Installation Harness 102193 5' 102194 10' 102195 20' Pressure Transducer 1/4 NPT FLUID TANK Adapter 3/4-1/4 NPT Bushing (OEM) Foam adapter is supplied when a foam level system is ordered. 3/4 NPT Elbow (OEM) The transducer must be mounted vertically as depicted to insure an accurate and reliable reading.
PAGE 3
Engineering Standards Name Tank Level Display Identifier Installation Information Engineering Standard Number C1-102245-A Electrical The Aerial Warning Display is connected to the OEM harness with a Deutsch 8 pin mini-connector.
PAGE 4
Engineering Standards Name Tank Level Display Identifier Installation Information Calibration Basic Calibration: With the fluid tank empty, enter the calibration password. L L L R R R The left (0%) bar will flash to indicate that you are ready to calibrate for an empty tank. Activate the right switch followed by the left switch. The right (100%) bar will flash to indicate that the display is ready to calculate for a full tank. When the tank is full, actuate the right and then the left switch.
PAGE 5
Engineering Standards Name Tank Level Display Identifier Installation Information Engineering Standard Number C1-102245-A The tank level gauge has a bar traveling back and forth across the display. There is a problem with the pressure transducer (PN 102162) or wiring. At the transducer connector, check for 5 VDC between pins A (+5 VDC) and pin B (ground). These are sent from the display and must be of the correct polarity for the transducer to function.