Owner manual

ManualsBrandsClass1 ManualsFor the carITL Tank Level Driver Module 107451

Intelli-Tank Manual (106759) 050304 – 1 – Class 1

Intelli-Tank

High current 4 light remote

driver module

with auto refill and alarm

Contents …………………………………………………. 1

Overview …………………………………………………. 2

Operation …………………………………………………. 3

Installation and

Wiring

………………………………………………….

Specifications …………………………………………………. 8

Troubleshooting

…………………………………………………. 9

Summary of content (9 pages)

PAGE 1
Intelli-Tank High current 4 light remote driver module with auto refill and alarm Contents …………………………………………………. 1 Overview …………………………………………………. 2 Operation …………………………………………………. 3 Wiring …………………………………………………. 5 Specifications …………………………………………………. 8 Troubleshooting ………………………………………………….
PAGE 2
The Intelli-Tank Driver module utilizes the 1-wire data line to receive tank level information from a Master 4 light tank level display (C1-PN 106299 or 106296) and then mimics the Master’s display with its high current outputs. The module also incorporates an auto-refill function that, when activated, turns on the fill output at less than ¾ tank level and turns it off when the tank reaches the FULL point.
PAGE 3
When the unit is first powered up the lights will cycle on individually starting with the EMPTY (output 1) light and then the lights will show the current status. • A Module connected to a Master unit (through the 1-wire data line) will mimic the Master unit’s LED condition and flash rate. • A Module not connected to a Master unit will alternately flash the upper two lights and the lower two lights. This indicates a “no data” condition.
PAGE 4
The auto-fill function will energize the fill output when the tank level is at or below ¾ and deenergize when the Master display reads FULL. Auto-fill will also de-energize the fill output and turn off the auto-fill status light if there is no data being received on the data line from the Master display (serial error) or if a transducer error high or low (range error) is encountered. 4 Outputs for the level lights Four outputs are available to drive external lights to indicate tank level.
PAGE 5
Driver Module The module is water tight and can be mounted any place away from large RF noise generators.
PAGE 6
Typical installation Connector detail Intelli-Tank Manual (106759) 050304 –6– Class 1
PAGE 7
Power and Ground It is imperative that the driver module and the Master tank level have a common ground. Stud Vehicle power Pin 12 Ground (12/24VDC) High Current Outputs (7.
PAGE 8
Parameter Value Unit +10 to +32 VDC @ 13.8VDC 44 mA @ 27.6VDC 55 mA -40 to 85 °C Alarm output 250 mA Auto-fill status light output 250 mA Fill output 250 mA External light outputs 7.
PAGE 9
Condition Evaluate Bottom two lights alternate flashing. Master tank level display’s transducer signal voltage is below .4VDC. Check transducer wiring to master tank level display. Top two lights alternate flashing. Master tank level display’s transducer signal voltage is above 4.80VDC. Check transducer wiring to master tank level display. Bottom two and Upper two lights alternate flashing. Remote driver module is not receiving data from the master tank level display.