Owner`s manual

10
2. DISPLAY INFORMATION AND VARIOUS MODES OF OPERATION: (Continued)
track using the NEXT (¾) and/or PREVIOUS (½) buttons, or with the numeric keypad on the
remote control. Then press PLAY. The disk will play from that point on until the end of the disk. While
playing, the display will show each track currently playing along with the elapsed time from the
beginning of that track. Once the disk is over, the CDP-1.5 will return to STOP mode.
Playback of only selected tracks
You can program the CDP-1.5 to play any combination of tracks on a disk, up to a maximum of
20. Using the NEXT (¾) and PREVIOUS (½) buttons, or the numeric keypad, find the first desired
track on the display. Then press the STORE button. Repeat this procedure until all desired tracks have
been stored. As each track is being stored, the display indicates the total playing time of all tracks
currently programmed. Press PLAY. Playback will commence from the first programmed track, and all
programmed tracks will play in the order they were stored. Please note that:
- If you try to program more than 20 tracks, no more tracks will be entered into memory.
- During programmed playback, the numeric keypad is disabled; use NEXT and PREVIOUS to
change tracks.
- The programmed tracks don't have to be in ascending numerical order; i.e. you can program
track 2 to play after track 6.
- If you programmed a track by accident, simply press CLEAR, that track will be deleted from
memory.
- To clear all the tracks programmed in memory, press the STOP button twice if the CDP-1.5 is
already playing, or once if it is not. If you intend on changing the disk, simply opening the
disk tray automatically erases all programmed tracks from memory.
Playback using REPEAT
Pressing the REPEAT button will have the unit repeating the entire disk. Once the REPEAT
mode is chosen, press PLAY.
The REPEAT feature can also be used with tracks programmed in memory in the same way as above.