Instruction manual

102 Concerto — Instruction Manual
Section 3 — Control System Configuration
Matrix Controller Factory Defaults
This read-only page shows the factory default settings for the Concerto
system. The
Factory Defaults button on the Network Configuration page is
used to restore these settings (see Figure 58 on page 98).
Figure 62. Matrix Controller Factory Defaults Web Page
Note IP addresses set on a Concerto Matrix Controller with the Factory Defaults
button on the Concerto Matrix Network Configuration web page
(192.168.1.134 primary, 192.168.1.135 secondary) are different from the IP
addresses manually set on a Concerto at the factory before shipment.