Instruction manual

108 Concerto — Instruction Manual
Section 3 — Control System Configuration
AES Attributes
This section contains information for the AES Attributes as they are config-
ured using a SMS7000 GUI. Encore settings
are slightly different but the
underlaying principles are the same.
The
Output Attrib Info and Input Attrib Info buttons are enabled when there is a
check in the
AES Attributes box. Some of these attributes require Concerto-
specific settings.
AES Output Attributes
1. Click the Output Attrib Info button to access the settings for output
attributes. Use this dialog to set the outputs individually or in groups.
Note Asynchronous Output (or input) is not supported by Concerto.
Figure 69. AES Output Attributes Dialog
Outputs can be assigned Soft Mute/No Soft Mute individually, in groups, or
by using the
All buttons. The Soft Mute/No Soft Mute attribute is a soft mute
or alignment of one signal’s amplitude to another signal’s amplitude at
switching. Some users call this audio dunking. Soft mute prevents a
crack or pop at switching.
Note The 20/24 Bit attribute is not supported by Concertos controlled by
SMS7000.
2. When you’ve finished assigning Output attributes click Ok to finalize
your settings.