Instruction manual
Concerto — Instruction Manual 113
Jupiter Crosspoint Bus Controller Configuration
Jupiter Crosspoint Bus Controller Configuration
If you are using a Jupiter Control System you will need to follow the
instructions for matrix configuration found in the Jupiter Installation and
Operating Manual. The Crosspoint Bus Controller (CRS-MC-C2) requires
specific settings. This section highlights those distinctions.
CAUTION If you are using a CRS-MC-C2 Controller module, the mode setting on DIP
Switch bank S11 must be set correctly before it will communicate the Cros-
spoint Bus. See Control Mode/In Sel Setting on
page 93.
Crosspoint Bus Controller Settings
On the CRS-MC-C2 there are nine banks of DIP Switches (8 position with J
leads) and two Rotary Switches. See Figure 74.
Figure 74. Crosspoint Bus Controller Switch Locations
8138_03_76r0
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
PWR
OK
DONEACT
GND
+5V
ERROR
TC2
PRES
BUSY
48K
PRES
LINK
SYNC
ERR
RECV
VI 2
PRES
XMIT
VI 1
PRES
CLEAR MEM
RESET
TX
RXFAST COL TC1
PRES
+2.5V
+3.3V
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
CLEAR MEM
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
DIP Switches
S10 (D_OPTIONS)
S9 (D_LEVEL)
S8 (C_OPTIONS)
S7 (C_LEVEL)
DIP Switches
S2 (A_LEVEL)
S3 (A_OPTIONS)
S4 (B_LEVEL)
S5 (B_OPTIONS)
Rotary
Switch
Rotary
Switch
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
18765432
ON
Each bank has 8 DIP Switches with On and Off settings. The banks are
labelled with the DIP Switch position #
1 through #8 and ON. There are only
two settings for each position, On or Off. The Rotary Switches have sixteen
positions #
0 through #F which are labelled on the face of the switch. The
Rotary Switches face toward the LEDs on the module.
Before you can configure the Rotary and DIP switches you need to deter-
mine the physical configuration of the Concerto Matrix. Refer to Optimum
Matrix Configurations on
page 26 to identify supported module configura-
tions.