Instruction manual

116 Concerto — Instruction Manual
Section 3 — Control System Configuration
empty slots and know what module you will be using to fill the empty
slots, then use the setting for that configuration.
Note If your configuration is not found in the table then your modules are not in a
supported hierarchy. Refer to Table 6 on page 26 and Optimum Matrix Con-
figurations o
n page 26.
CAUTION The maximum number of HD modules that can be in a 7 RU Conce
rto frame
is three in which case the fourth slot has to remain empty. If two HD modules
are used then the other two slots can be loaded with any of the non HD mod-
ules.
Table 46. S13 Rotary Switch Settings for Matrix Mapping
a
a
Video = Analog, SD, or HD; Audio = Analog or Digital; Data = Port or TimeCode
Setting
CLEAR MEM
S2 S5
S11S10
S13
S12
S4S3
S9S8S7
A_LEVEL B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL S11
S12 S13
A B C
D
E
F
G H
A B C
D
E
F
G H
A B C
D
E
F
G H
A B C
D
E
F
G H
MATRIX MAP
CONFIG
Format of Module in Slot
1 2 3 4
0 Video Video Video Video
1 Video Video Video Audio
2 Video Video Audio Audio
3 Video Audio Audio Audio
4 Audio Audio Audio Audio
5 Video Video Video Data
6 Video Video Data Data
7 Video Data Data Data
8 Audio Audio Audio Data
9 Audio Audio Data Data
A Audio Data Data Data
B Video Video Audio Data
C Video Audio Audio Data
D Video Audio Data Data
E Data Data Data Data
F Undefined
4. Set crosspoint bus type.
CLEAR MEM
S2 S5
S11S10
S13
S12
S4S3
S9S8S7
A_LEVEL B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL S11
S12 S13
A B C
D
E
F
G H
A B C
D
E
F
G H
A B C
D
E
F
G H
A B C
D
E
F
G H
MATRIX MAP
CONFIG
Select Super crosspoint bus type by setting DIP Switch number 8 of
bank S2 to Off. On is for future use.
5. Set DIP Switch number 8 of bank S9 to designate Master Controller.
.
CLEAR MEM
S2 S5
S11S10
S13
S12
S4S3
S9S8S7
The Controller module in Controller Module slot 1 (CMS1) can be des-
ignated as the Master Controller by se
tting this switch to On.