Instruction manual
Concerto — Instruction Manual 119
Jupiter Crosspoint Bus Controller Configuration
Table 50 shows the option setting choices for Audio modules.
Table 50. Audio Option Settings for DIP Switch Banks S3, S5, S8, and S10
a
a
Switches 5 through 8 undefined.
CLEAR MEM
S2 S5
S11S10
S13
S12
S4S3
S9S8S7
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
DIP Switch # Position Condition
1
ON Mono (not supported)
OFF Stereo (default)
2
ON Expanded system - more than one Concerto frame
OFF Not Expanded - one Concerto frame
3
ON
If Switch # 2 is On, module is
in expansion frame (I/O 129-256)
If Switch # 2 is Off, this setting is invalid
OFF
If Switch # 2 is On, module is in base frame of expanded syste
m (I/O 1-128)
If Switch # 2 is Off, single
frame.
4
ON 24 bit processing
OFF 20 bit processing
Table 51 shows the option setting
choices for Data modules.
Table 51. Data Options Settings for DIP Switch Banks S3, S5, S8, and S10
a
a
Switches 2 through 8 undefined.
CLEAR MEM
S2 S5
S11S10
S13
S12
S4S3
S9S8S7
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
DIP Switch # Position Condition
1
ON TimeCode
OFF Port
7. Complete the configuration on the Jupiter Control System.
On the Jupiter Control System configuration a Concerto matrix is con-
figured as a standard crosspoint bus control router using the Switcher
De
scription, Input, and Output tables. On the Switcher Description
table, select
Binary as the Driver type.
The location (output number) of the Concerto Monitor output in non-
expanded s
ystems is the next output following the main matrix. For
example, for a 64 x 64 router the Monitor output number would be
65.
For expanded systems, the Monitor is the next output following the
main matrix, assuming that the expansion is fully populated. This is
because the Base matrix has no knowledge of the size of the Expansion
matrix, so it has to assume the maximum possible.
For more information on the Jupiter Contr
ol System configuration,
refer to the Jupiter Getting Started Guide, and the Jupiter Installation and
Operating Manual.