Instruction manual
126 Concerto — Instruction Manual
Section 4 — Maintenance and Troubleshooting
Jupiter Controlled Non-Redundant Systems
1. Inspect the new Controller module.
2. Set each of the 9 DIP switch settings and two rotary switch settings to
match that of the currently installed Controller.
These can be viewed on the currently used module while it is active in
t
he Concerto chassis. Note the status of the LEDs on the front edge of
the module.
Figure 79. DIP Switches and Rotary Switches
0732_00_1r0
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
PWR
OK
DONEACT
GND
+5V
ERROR
TC2
PRES
BUSY
48K
PRES
LINK
SYNC
ERR
RECV
VI 2
PRES
XMIT
VI 1
PRES
CLEAR MEM
RESET
TX
RXFAST COL TC1
PRES
+2.5V
+3.3V
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
18765432
ON
CLEAR MEM
A_LEVEL
B_LEVEL
A_OPTIONS
C_LEVEL
D_LEVEL
B_OPTIONS
C_OPTIONS
D_OPTIONS
MODE/IN
SEL
S11
S12
S13
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
A
B
C
D
E
F
G
H
MATRIX MAP
CONFIG
Rotary
Switch
Rotary
Switch
3. Remove the old Controller module.
4. Insert and seat the new Controller module.
The
PWR OK (power OK) and DONE LED will light signifying the module
is up and ready to receive commands. The next command sent from the
control system will cause the
ACT (active) LED to turn on.
The next command sent from the control system will cause the
ACT LED
to turn on. Continued commands cause the
ACT LED to flash.
5. Send a switch command from the control system and verify that the
switch was executed.
Encore Controlled Redundant Systems
1. Inspect the new Controller modules.
2. Set the DIP Switch bank S11 switch number 1 to ON. Switches 2 to 8 are
set to
OFF.
3. Remove one old Controller module.