Instruction manual

Concerto — Instruction Manual 95
Ethernet Interface Configuration
The NetConfig application can be used to change IP addresses and load
software to devices on a network.
CAUTION If you are using a CRS-MC-C2 Controller module, the mode setting on DIP
Switch bank S11 must be set correctly before it will communicate using
Ethernet. See Control Mode/In Sel Setting on page 93.
IP Address Setting Using NetConfig
1. Double-click on the NetConfig icon to launch NetConfig (see
Figure 55). The main NetConfig window will appear.
Figure 55. Matrix Controller Invalid IP Address
2. Select Device IP Addresses on the Configure menu to access the Change IP
Addresses
window.
3. Select the Concerto Controller on the list (you can narrow the selection
with the category drop down menu). Change Concerto’s Controller
Module IP setting(s) to the same subnet as your Control System (See
Figure 56). For details on using NetConfig for these procedures, see the
NetConfig Instruction Manual.