Instruction manual

Concerto — Instruction Manual 97
Ethernet Interface Configuration
Figure 57. Concerto Matrix Description
IP Address Setting Using Concerto Web Pages
The IP addresses on a Concerto controller can also be changed directly from
it’s web page, provided the PC used is configured with a compatible IP
address compatible. However, it is more convenient to use NetConfig for
this purpose, because it can list devices even the device is not configured
directly on the network. Refer to the NetConfig Instruction Manual for
detailed information.
If you know the existing IP address of the Concerto Mat
rix controller, you
can access it from a properly configured computer. Once the Concerto web
page is displayed, the IP address is changed by going to the Network Con-
figuration screen (Figure 58). The Concerto Matrix controller will need to
be reset to make any changes take effec
t. This is accomplished by checking
the
Do Reset box and then clicking on the Save New Settings button at the
bottom of the screen, as shown in the example screen.