Instruction manual

Concerto — Instruction Manual 99
Concerto Web Pages
Note Unpredictable system behavior is likely if different versions of software run
in your facility.
Figure 59. The Update Devices Dialog Box
6. Ensure that the Re-Boot when complete checkbox is checked and click the
Load button.
7. After the Concerto Controller reboots, verify that the correct software
version is now loaded using the Concerto Matrix Description window.
See Figure 57 on page 97.
8. Exit NetConfig. Your Concerto changes are complete.
Concerto Web Pages
The Concerto system offers web pages to report system status and allow
configuration changes. These Web pages are accessible with a PC config-
ured on the same network. Various web
pages are displayed by clicking on
the names of the pages on the left side of the screen.
The Concerto Controller must be reset before most changes will take effect.
This i
s accomplished by checking the
Do Reset box and then clicking on the
Save New Settings button at the bottom of the screen.
The
Concerto Matrix Description (Figure 57 on page 97) and Concerto Matrix
Network Configuration
pages (Figure 58 on page 98) are illustrated earlier in
this document. The following Concerto we
b pages are also available: