Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 111

AccuSwitch Configuration File Overview

When a Configuration set is activated from the Control Center a zipped

copy of the configuration will be downloaded to the AccuSwitch control

board. Uploaded sets, which are named _Active.zip and _Prev.zip, are

placed in the Jupiter\Logdata directory.

In order to work with an uploaded set, you will need to use the existi

Unzip Configuration Set menu option (Tools > Unzip Configuration Set

menu) to unzip the _Active.zip and _Prev.zip files. You should rename the

configuration to avoid any conflicts the next time a Configuration file is

uploaded. You can then edit and compile the set as you would any other

set.

Note There will not be a _Prev.zip file when only one configuration has been sent

to an AccuSwitch control board.

A Clear Flash command will remove the Previous Configuration file on an

AccuSwitch board. However, a Clear Flash command, on a Jupiter Xpress

board will not remove the Previous Configuration file.

Configuring a New Set

Note For more information about each of the tables, see the specific table descrip-

tion in this chapter.

The tables that are needed to configure a new set are:

• The Network Description table

•

The Serial Protocol table

• The Switcher Description table

• The Switcher Input table

• The Switcher Output table

Creating Control Panel Sets

The Control Panel Set dialog provides inputs, outputs, levels, sequences

and overrides to the Jupiter Control Panels (CP) in the system.