Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 115
AccuSwitch Configuration File Overview
Figure 78. The CM-4000 Configuration Information screen)
3. Click the Broadcast button if all CM-4000s are not listed. All running CM-
4000s that are connected to the network should then be displayed
regardless of subnet.
Note If you do not see any CM-4000s listed when the Multicast button is selected,
you may need to set the Gateway and Subnet Mask in the Jupiter Settings. Go
to “Tools > Jupiter Settings.” Then fill in the Gateway and the Subnet Mask.
After editing and saving your changes, you may need to reboot the CM-4000s
in order to see them listed for the multicast scope.
4. Select one of the CM-4000s and then click the Upload Configuration Sets
button.
Figure 79. The CM-4000 Configuration Information screen)