Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 131
Configuration Set Management
The NUMERIC sets are factory-supplied sets provided for quick start and
diagnostic purposes. For more information, see Using the Numeric Sets for
Quick Switcher Checkout o
n page 132. The list may also contain a test set used
at the factory.
Figure 91. Selecting Edit Set Menu
2. Select the desired set name and then click the OK button. The set will
then load.
3. Select the Save As option under the File menu (File > Save As).
4. Enter a new name for the set (up to eight characters).
When creating a name for a Jupiter set, table, control panel, or other device,
it’s
a good practice to use letters and numbers only. If you want to use punc-
tuation or special characters, see Jupiter Naming Rules on page 128 before cre-
ating a name.
5. Click the OK button. The copied set will then be the active set when the
set has finished copying.
Making the Desired Modifications to a Configuration Set
Editing procedures for specific modifications are described in this manual,
starting with the Network Description Table on pa
ge 149. From the Network
Description table, you should move on to the Ser
ial Protocol table, then the
Switcher Description table, and so on through the remaining Jupiter tables.
Note As previously explained, you cannot enter data on “secondary” tables first.
For example, you must enter a new CM 4000 on the Network Description
table. In general, data should be entered in the same order as the tables
appear in the pull-down menu. For more information, see Automatic Table
Entry on page 119.