Instruction manual

136 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Note A reboot will occur when the operator executes any operation from the
Control Center that will cause a reboot or a “Pmem Clear” to be sent to the
processor, or by manually rebooting, or clearing Pmem on the processor
from the shell prompt, or by pressing the Reset button.
The purpose of the Pending Reboot procedure is to provide the operator
better control of system downtime. The download process, which may be
rather lengthy in large systems, does not interfere with normal operations.
This allows the Reboot step, which is much shorter (but will interrupt
switching operations), to be scheduled at an appropriate time.
Figure 95. Example of a “Pending Reboot”
Follow these steps to apply the Download now / Reboot later procedure:
1. Open the Control Center and click the Configuration tab.
2. Select the Select and Reboot radio button in the On Activation area.
3. Select a Configuration set and then click the Activate button (Figure96).
Source
set
selected
for editing
Compiled set(s)
Source sets
Compile
Select for
editing
Save
Set
selected
for
download
Select and
process
Application
(executable code)
FILE SERVER
CM 4000
Copy of
Application
(executable code)
Downloaded
Set
Executing
Application
Operating
set
Reboot
“Activate”
(Download)
Reboot
Control panels
Router
“Activate”
(Download)
071182105_Example of a pending reboot