Instruction manual

138 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Figure 97. The Jupiter Control Center- Configuration Pending Reboot
Likewise, the system will compare the application code that was down-
loaded with the application code that is currently in operation. If they are
dif
ferent, the cell will be red and the phrase Pending Reboot will appear in
the Code column. This Pending Reboot condition for the application code
is shown in Figure98.
Figure 98. The Jupiter Control Center-Code Pending Reboot
Due to the size of the application, the operator may observe the phrase Mis-
match in the Code column while the download is in progress. The operator
s
hould wait until the phrase Pending Reboot appears in the Code column
before continuing.
CM 4000
Copy of
Application
(executable code)
Downloaded
Set
Executing
Application
Operating
set
Reboot Reboot
“CONFIGURATION
PENDING REBOOT”
is indicated when
these two sets do not
match
071826105_CONFIGURATION PENDING REBOOT
CM 4000
Copy of
Application
(executable code)
Downloaded
Set
Executing
Application
Operating
set
Reboot Reboot
“CODE
PENDING
REBOOT” is
indicated when
these two sets
do not match
071826105_Code Pending Reboot