Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 171
The Control Panel Set Dialog
The Control Panel Set Dialog
The Control Panel Set dialog is where the inputs, outputs, levels, sequences
and overrides for the control panels in the system are defined. This dialog
is dynamic and will change according to the sets that are selected.
Once a set has been created, selecting the ty
pe of set will open that sets
table. This table is where the configuration information is stored.
Creating a CP Set
This section provides the steps that will be used for all of the Control Panel
sets. For example, The Control Panel Input Set, The Control Panel Output Set,
The Control Panel Level Set, The Control Panel Category Set, The Control Panel
Override Set, The Control Panel Sequence Set.
Figure 121. The Control Panel Set Dialog
Follow these steps to create a CP set:
1. Select the Control Panel Sets from the Jupiter menu (Jupiter> Control
Panel Sets...) or press the
F8 key on your keyboard. The Control Panel
Sets dialog will then open.
Note Selecting a particular type of set will change the name of the window below
the Type of Set area. For example, the window is called Input Sets if the Input
radio button is selected (Figure 121 on page 171).
The saved sets are
displayed according
to the Type of Set
that is selected
The Category Set drop-
down list apples only to
the Input and Output radio
buttons