Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 179

The Control Panel Output Set

The Control Panel (CP) Output sets are assigned to the specific control

panels, which are defined on The MPK Devices Table on

page 191.

Do NOT give an Output Set the same name as an output. Using

an exten-

sion such as “OUT” is recommended to help avoid potential conflicts.

Since each control panel can be assigne

d a different CP Output Set, these

sets are usually used to control access to outputs on a panel-by-panel basis:

• You may want a control panel in the master control room to have access

all possible outputs. This panel might be assigned to Output Set

“MC-OUT,” which includes a category/number entry for all destina-

tions.

• You may want a control panel in a particular department to have access

to only a selected number of outputs. This panel would be assigned to

an Output Set (such as “NEWS-OUT”) which has only those outputs

listed.

Note If you want the panel to be restricted to a single output, you could instead use

the technique already described, whereby the name of the output, rather than

the name of an Output Set, is entered on the MPK Devices table.

Creating a CP Output Set

For steps activating the Control Panel Set dialog, see Creating a CP Set on

page 171.

Figure 127. The Control Panel Sets Dialog - Output Set