Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 185
The Control Panel Sequence Set
Figure 131. Control Panel Sets - New Sequence
5. Click the Open Table button to open the sequence. The Sequence Set table
will then appear (Figure132).
Figure 132. The Sequence Set Table
Adding or Editing Sequences
Follow these steps to add (or edit) a sequence:
1. Enter a name for the first sequence by typing a name in the Sequence
column.
2. Select the first input name from the Logical Input column’s drop-down
list. (The source for these names is the Switcher Input table).
3. Select the first output name from the Logical Output column’s drop-
down list.
4. Double-click in the Levels column’s field. The Level Select dialog will
then appear.
a. Select the Levels to activate from the available Levels.
b. Click the Ok button.
5. Save your changes and then click the OK button.
6. Validate, compile, and then activate the configuration set.
1
Sequence Set − KXYZ−SEQ
Sequence
SEQ1
Input
VT01
Levels
YYYY
2
3
4
SEQ1 VC01 YYYY
SEQ1 VC02 YYYY
SEQ2 CAM1 YNNN
Output
PRDA
PRDB
PRDC
MON1
...
...
...
...
Logical Logical
071876600_SeqenceSetTable