Instruction manual

192 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Board column: The name of CM-4400 connected to the control Panel. The
source of this name is the Jupiter Network Description table.
Port column: The port num
ber that is configured for ESCP to which the
panel is connected. ESCP is defined in the Serial Protocol Table.
Address column:
The panel address from 1 to 16 for ESCP (serial panels)
and 1 to 64 for LAN panels. This address must be unique for panels sharing
the same CM-4400 serial port. Panels are normally shipped with a panel
address of “01.” This number is referred to as the “Device Number” on the
IP configuration page and “ID” within the L-S or LCD Panels MENU
system.
Input Sets column: Input
and output set types should be CPESXTND for
Device type CPES-SER.
In Panel columns: T
his column is used only for configuring an expansion
panel. This column is not used for L-S or LCD panels.
Out Set column:
Input and output set types should be CPESXTND for
Device type CPES-SER. If the entry is an actual CP Output Set, then the
control panel will be able to control all the outputs listed in that Set.
Depending on the con tents of the set, this would allow for full-matrix or
multi-bus control.
Out Panels column: This c
olumn is used only for configuring an expansion
panel. This column is not used for L-S or LCD panels.
Level Set column: Select the CP Level Set
name.
Override Set column: Select the CP Overr
ide set name.
Sequence set column: Select
the CP Sequence set name.
Configuring a Control Panel for Full-matrix, Multi-bus, Or Single-bus
Control
The CP Output Set entry on the MPK Devices table determines which
outputs can be controlled by a control panel. These steps assume that the
MPK Devices table is already open.
Follow these steps to configure a Contr
ol Panel for Full-matrix, Multi-bus,
Or Single-bus Control:
1. Click in the Output Set field that you want to change.
2. Enter the name of the preferred CP Output Set (for full/multi−bus
operation), or select the name of a single switcher output (for single bus
operation). For more information about creating an Output Set, see The
Control Panel Output Set on page 179. The source of the output names is
the Switcher Output table.