Instruction manual

202 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Figure 149. Path Finding and Switcher Inputs tables for system shown in Figure148
Sequential Path Finding
Tie lines from
“NewsRout” to
“MAINROUT”
Tie lines from
“MainRout” to
“NEWSROUT”
See note 1
Path Finding Line Physical Physical
Group Name Number Output Input
Non−Sequential Pathfinding
1 GROUP1 3 83 87
2 GROUP1 4 84 88
3 GROUP2 3 83 87
4 GROUP2 4 84 88
5 GROUP3 3 83 87
6 GROUP3 4 84 88
7 GROUP4 3 83 87
8 GROUP4 4 84 88
9 GROUP5 2 82 20
10 GROUP6 2 82 20
11 GROUP7 2 82 20
11 GROUP8 2 82 20
Note 1: You may wish to define each and every tie line on the Non−sequential table; however, it will
still be necessary to enter some number in the Physical Output and Physical Input columns to satisfy
the compiler.
GROUP1
Non−sequential
tie lines
Logical Input
Name VIDEO LEFT RIGHT TC
30 VT21 033 033 033 033
31 VT22 034 034 034 034
45 VT15 GROUP5 GROUP6 GROUP7 GROUP8
46 VT16 GROUP5 GROUP6 GROUP7 GROUP8
Switcher Input − NewsRout
Logical Input
Name VIDEO LEFT RIGHT TC
23 VT15 001 001 001 001
24 VT16 002 002 002 002
45 VT21 GROUP1 GROUP2 GROUP3 GROUP4
46 VT22 GROUP1 GROUP2 GROUP3 GROUP4
Switcher Input − MainRout
Group
nAME
See note 1
See note 2
Note 2: in this example, the same input/output numbers are used for
the tie lines on each level; however, different inputs/outputs can be
used, and entered on this table, if desired.
lacisyhPlacisyhPgnidniF htaP
Group Name Source Switcher/Level Output Destination Switcher/Level Input Count
1 GROUP1 VIDEO (NEWSROUT) 13 VIDEO (MAINROUT) 44 5
2 GROUP2 LEFT (NEWSROUT) 13 LEFT (MAINROUT) 44 5
3 GROUP3 RIGHT (NEWSROUT) 13 VIDEO (MAINROUT) 44 5
4 GROUP4 TC (NEWSROUT) 13 TC (MAINROUT) 44 5
5 GROUP5 VIDEO (MAINROUT) 61 VIDEO (NEWSROUT) 26 3
6 GROUP6 LEFT (MAINROUT) 61 LEFT (NEWSROUT) 26 3
7 GROUP7 RIGHT (MAINROUT) 61 RIGHT (NEWSROUT) 26 3
6 GROUP8 TC (MAINROUT) 61 TC (NEWSROUT) 26 3