Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 209
Point-to-Point Switching
In the example above (Figure154), VCR 1 is the only destination that is
receiving data from the editor. The transmit data fr
om an editor can only be
switched to one VCR at a time.
Point-to-Point Switching Router Options
The router options are explained below:
Enforce:
When the Enforce option is selected or turned on, the software
will automatically switch the previous destination to the SAFE input. The
control device would then be switched to a new destination.
Advise:
When the Advise flag option is on and an attempt is made to
switch control to a new device, the switch will not occur. The system will
display the following message on the control panel in two lines if the
selected source is used by another destination:
SRC in use
by: <Destination name>
The switch to a new device will
not be executed until the destination that is
using the source is either:
• Switched to a different source.
•
Switched to the “SAFE” input.
This option will avoid having the contr
ol device connected to two
machines at the same time.
Note The Advise and Enforce options do not work when you are using Sequences
or Multiple-destination switching when the same source is being routed to
more than one destination.