Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 213
Remote System Routing
Follow these steps to modify the Network Description table for System 1
(SYS1):
1. Enter a name for System 1’s CM-4000 in the Board Name field. SYS1 is
used in the example above.
2. Select the AS option from the Type drop-down list.
3. Enter the CM-4000’s hardware address in the Address column.
Follow these steps to enter the System 2 (SYS2) information on the Network
De
scription table for System 1:
1. Enter a name for System 2’s CM-4000 in the Board Name field. SYS2 is
used in Figure 156 on page 212 .
2. Select the ES option from the Type drop-down list.
3. Enter the IP address for SYS2’s CM-4000 instead of the hardware
address in the Address field.
Network Description table on System 2’s Server
The Network Description table on the server in System 2 has entries for the
two local CMs and an entry for the SYS1 CM (Figure157). The IP address
for the SYS1 system has ES (ES−LAN) in the T
ype field and has IP address
(192.168.253.10) entered in the Address field.
Figure 157. Example of the Network Description Table on the System 2 Server
Follow these steps to modify the Network Description table on the System
2 Server:
1. Enter a name for System 2’s CM-4000 in the Board Name field. SYS2 is
used in the example above.
2. Select the AS option from the Type drop-down list for SYS 2.
3. Enter the CM-4000’s hardware address in the Address column.
4. Enter the information for the second local CM-4000, change the
information as necessary.
5. Enter the name for System 1’s CM-4000 in the Board Name field. SYS1
is used in Figure157 .
6. Select the ES option from the Type drop-down list.
27512_Network Description table_Sys
004053011C22
Redundant
2
Network Description
Board Name
SYS2
AS
Address
3
CM1 SB 004053011C23
1
Type
Address
SYS1 ES 192.168.253.10