Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 217
Remote System Routing
CP Level Set Tables
The CP Level sets that are assigned to the WAN CM (on the MPK Devices
Ta ble s, which is explained on page 218) must be created as
type CP−3000."
Figure163 shows the CP Level Set for SYS1 (System 1).
Figure 163. Example of the CP Level Set on the System 1 Server
Figure164 shows the CP Level Set on the SYS2 (System 2) server.
Figure 164. Example of the CP Level Set on the System 2 Server
In the example above:
• The PLvl number ”100" on the System 1’s (SYS1) Switcher Description
table (Figure 160 on page 215) converts to modulo ”0," which in turn
points to row 1 in Figure164 above.
• This index number identifies the name of the target Level, which is
VIDEO(SYS2) in the example above.
• This name in the level column points to the corresponding Level name
on System 2’s Switcher Description table (Figure 162 on page 216).
071827512_CP Level Set_System 1
1
CP Level Set — KXYZ−LVL
Mnemonic Level Break Switch
2
3
VIDEO VIDEO(SYS1)
LEFT LEFT(SYS1)
RIGHT RIGHT(SYS1)
4
071827512_CP Level Set_System 2
1
CP Level Set — KXYZ−LVL
Mnemonic Level Break Switch
2
3
VIDEO VIDEO(SYS2)
LEFT LEFT(SYS2)
RIGHT RIGHT(SYS2)
4
Index number “1”
from System 1’s
Switcher Description
table (Figure 160 on
page 215) maps to the
second row
Maps to the local Switcher Description
table (Figure 162 on page 216)