Instruction manual

218 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
MPK Devices Tables
Although the CM is not an MPK device as such, the MPK table is used to
assign the CM with an Address that can be used by a remote system.
Follow these steps to add the Remote Routing information:
1. Enter a name for the SYS1 CM in the MPK Devices field. The name
entered for the CM is arbitrary; however, the name should identify the
local system.
2. Select the ES−RMTR option from the drop-down list in the Device Type
field.
3. Select the name for the CM from the drop-down list in the Board
column. This Board entry is the name that was entered in the Network
Devices table (see Figure 156 on page 212).
4. Enter a two−digit ES-LAN Device number that is from 65 to 75 in the
Address column. This number must then be entered in the Option 1
column of the Switcher Description tables that describe levels
connected to this CM.
Note Numbers 1-64 in the Address column are reserved for panel IDs.
For example, Figure165 shows the MPK table that resides on System 1’s
server.
• The SYS1’s CM-4000 address has been set to “65.” This address has
be
en selected on the Option 1 column of the SYS2 Switcher Description
table (Figure 162 on page 216).
Figure 165. Example of the MPK table on the System 1 Server
5. Follow the steps above to enter the information in the MPK for SYS2.
Figure166 shows the MPK table on the SYS2 (System 2) server.
JEP1 ES−LAN
SYS1
TUO−ZYXKPNI−ZYXK10
S1 ES−RMTR
SYS1
65
TUO−ZYXKPNI−ZYXK
1
MPK Devices
MPK
Expansion
Pass
Board Port Address Input Sets Output Sets Level Set Overide Set Sequence Set
2
drowseciveD
In Panel Out Panel
Device
Type
KXYZ−LEV
KXYZ−LEV
Enter a name
for the SYS1
CM
Select the
ES−RMTR
option
Select the
name for the
CM
Enter a
two−digit
number