Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 219
Remote System Routing
Figure 166. Example of the MPK table on the System 2 Server
The Switcher Input Tables - SYS1 Server
The Switcher Input tables are used to assign a logical name to each switcher
input. In the examples below, there is a table for the local router on SYS1
(Figure167) and another table for the remote router SYS2 (Figure168).
Note The Logical Input Names must be unique across these tables.
Entries on the Switcher SYS1 Input table (Figure167) are physical input
numbers. Only local input names are entered.
Figure 167. Example of the Switcher SYS1 Input table on the System 1 Server
Figure168 shows the Switcher SYS2 Input table on System 1 server
(example). Entries in this table are the "entry" numbers that ar
e used in the
CP-Input table and are used by the ES-RMTR device in the MPK table for
the remote system configuration. Only remote input names are entered.
Figure 168. Example of the Switcher SYS2 Input table on the System 1 Server
The serial-type CP Input set as described below.
CP Input Sets - SYS1 Server
In this example the CP Input Set in Figure170 is assigned via the MPK
Devices table. The serial−type CP Input set only contains
local input
names. This table is used by the ES-RMTR device in the SYS1 MKP devices
table for switch commands originating from SYS2.
S2 ES−RMTR
SYS2
TUO−ZYXKPNI−ZYXK66
CP1 CP−3000
SYS2
00000014
1
MPK Devices
MPK
Expansion
Pass
Board Port Address Input Sets Output Sets Level Set Overide Set Sequence Set
2 1
drowseciveD
In Panel Out Panel
Device
Type
KXYZ−LEV
TUO−ZYXKPNI−ZYXK
KXYZ−LEV
071827512_Switcher Input Tables − SYS1
1
Name
1BARS
RIGHT
VIDEO
2 1VT1
3 1VT2
4 1VT3
LEFT
000
003 003 003
Switcher Input − SYS1
000 000
Logical Input
001 001
002 002 002
001
071827512_Switcher Input Tables − SYS2
1
Name
2BARS
RIGHT
VIDEO
2 2VT4
3 2VT5
4 2VT6
LEFT
000
002
003
002
003
002
003
Switcher Input − SYS2
001
000 000
Logical Input
001 001
From the Logical Input
field on the CP Input
Set table for System 1
This information provides
the information for the
fields in the Entry column
for the Serial−type CP
Input Set on System 2