Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 221
Remote System Routing
Entries on the Switcher SYS2 Input table on System 2 server are physical
input numbers. Only local input names are entered.
Figure 172. Example of the Switcher SYS2 Input table on the System 2 Server
CP Input Sets - SYS2 Server
The inclusion of inputs to both systems allows bi-directional control.
Figure 173. Example of the CP Input Set table on the System 2 Server
Only local input names are entered on the Serial−type CP Input Set on the
System 2’s server.
Figure 174. Example of the Serial−type CP Input Set on the System 2 Server
Switcher Output Tables - SYS1 Server
The Switcher Output tables follow the pattern that was described for the
Switcher Input tables.
Each server has the customary Switcher Output table and CP Output set.
In addi
tion, each server has a special indexing Switcher Output table and a
special Serial−type CP Output set. See the example tables below.
1
Name
2BARS
RIGHT
VIDEO
2 2VT4
3 2VT5
4 2VT6
LEFT
000
002
003
002
003
002
003
Switcher Input − SYS2
001
000 000
Logical Input
001 001
071827512_Switcher SYS2 Input table
From the Serial−type
CP Input Set on the
System 2 server
Switch command to
router: “Select physical
input 000.” (END of
example sequence)
071827512_CP Input Set table
1
Input Set — KXYZ−INP
Category
Entry Mnemonic
Input
2
3
Test 1 1BARS 1BARS
VTR 2 1VT2 1VT24
5
Test 2 2BARS 2BARS
VTR 1 1VT1 1VT1
VTR 3 1VT3 1VT3
VTR 4 2VT4 2VT4
VTR 5 2VT5 2VT5
VTR 6 2VT6 2VT6
6
7
8
Logical
071827512_Serial−type CP Input
1
Input Set — SYS2INP (SERIAL)
2
1
2
Entry
2BARS
2VT4
3
3
2VT5
4 2VT6
0
Logical Input
From the fields on the
Video column of the
Switcher SYS2 Input
table
This entry provides the
information for the fields
in the Logical Input Name
column for the Switcher
SYS2 Input table on the
System 2 server