Instruction manual

JUPITER CM-4400 Control Module - Installation and Operating Manual 237
Figure 194. The Control Center Dialog
2. Click the Select and Reboot radio button in the On Activation section.
3. Select the Configuration set and then click the Activate button
(Figure194).
Note In order to download new application code, you must select a configuration
set for Activation even if it has the same name as the set shown as the Current
Set.
You will need to reboot the processor for the updated configuration file
code update to be applied.
Rebooting the Processor
Follow these steps to reboot the CM-4400’s processor:
1. Click the Board Info/Control tab on the top of the Control Center dialog.
The system will compare the configuration set and the application code
that
was just downloaded with the current configuration set and the
application code that is in operation.
• If the configuration set is different, the phrase “Pending
Reboot” will appear in the Configuration column (Figure195).
• If the application code is different, the phrase “Pending Reboot”
will appear as shown in (Figure196).