Instruction manual
JUPITER CM-4400 Control Module - Installation and Operating Manual 239
Figure 197. MISMATCH message
2. Select the processors by clicking the Select All button on the lower right
side of the interface (Figure197). It is recommended that you reboot all
the processors at the same time when updating code or a configuration
set.
3. Click the Reboot button or the Clear PMEM button on the top of the right
side of the interface. The OK message will then appear in both the
Configuration and Code columns.
Note For more information about the Clear PMEM button and the effects of
clicking this button see Clearing Persistent Memory (PMEM) on page 106.
Bootp
BOOTP is a network protocol that is used by a network client (the CM-
4400) to obtain an IP address from a configuration server. The Bootp tab
provides a log of the BOOTP transactions.
Clicking the
Clear button will erase the information in the log.
The Select All
Button