Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 261
CM-4400 System Codes
06 Unconfirmed and unasserted takes on
Xptbus.
The CM-4400 attempted takes on the Cross-point
Bus (XptBus) but the takes were unconfirmed and not
asserted.
This usually indicates an open connection to the
router or that the cross points were not valid for the
router. Check to make sure the XptBus cable is prop-
erly connected. If this does not fix the problem, dou-
ble-check the router's configuration.
07 Video SYNC locked to %s. The CM-4400 has locked to a valid SYNC reference.
When this occurs, SYNC is properly connected and
working. However, verify the SYNC standard is cor-
rect for the system.
08 Timecode acquired. The CM-4400 detected a valid Timecode signal.
When this occurs, Timecode is properly connected
and working.
Table 11. Messages 09 to 10
Message Number Short Message Detailed Description
09 Unexpected jump in timecode to
%02x:%02x:%02x:%02x.
The Timecode input has jumped to a value that is not
continuous with the current timeline.
This may be expected if the input was just acquired or
the Timecode generator was set to a new value.
Because the video timeline was adjusted abruptly,
some deferred events may be invalid. If this message
occurs without cause or the timecode value is unrea-
sonable, then check the generator and its connection
to the system.
0A Ethernet interface %s appears active. The CM-4400 detected activity on the Ethernet inter-
face.
When this occurs the Ethernet is properly connected
and working.
0B Unable to initialize udp socket The system was unable to initialize the Ethernet con-
nection. This is typically a critical error and will result
in lack of communication with other systems.
0C Output %d, level %d is locked. An attempt to switch the indicated output failed
because it was locked.
0D Output %d, level %d is protected. An attempt to switch the indicated output failed
because it was protected.
0E Failed to change from configuration
%s to %s.
The system failed to change the configuration. The
system will continue to function, but with the old
configuration set.
Check the new configuration set and try again.
Table 10. Messages 01 to 08
Message Number Short Message Detailed Description