Instruction manual

ZS00000112ZS00100212ZS00200312<CR>
ZROOOIIILLLLLLL
JUPITER CM-4400 Control Module Installation and Operating Manual 275
Table 31. Router Switcher Control and Status Commands
Command Meaning Description
ZSOOOIIILLLLLLL Switch Request This command causes the interface to issue a TAKE
Switch Request to the routing switcher control system and affects a
single routing switcher output. If no levels are specified, then ALL
defined levels are assumed.
Note
Passwords are not honored by automation pro-
tocol handling.
A remote computer can send a command with multiple Switch
Requests (older releases do not have this capability).
A single command can be up to 180 characters long which allows
switching of from 12-22 outputs (depending on the specified levels).
An example of a multiple Switch Request follows:
This example command would switch outputs 0, 1,
and 2 on levels 1
and 2.
ZROOO Status Request This command requests current switcher status for a single output.
The response is in the format:
If the status for the output is “split”, multiple responses will be
returned.
Z
WOOO Watch Output This command causes the interface to watch the specified output for
any changes and report such changes. A request to watch output
“
999” is a request to watch all defined outputs in that port’s serial
output set. All responses are in the “ZR” format described above.
When issued, this command also may result in an immediate
ZR
response for the requested output(s). No
ZR response(s) will be
returned if the requested output(s) do not have any inputs assigned
to them.
ZPOOO Lock Output This command LOCKS the specified output from being changed by
any system control device.
ZVOOO Protect Output This command PROTECTS the specified output from being changed
by any other system control device.
ZUOOO Unlock Output This command removes the LOCK or PROTECT from the specified
system output. If another system control device or interface locked or
protected this output, this command will fail.
ZJOOO Report Lock Status This command will return a code based on which kind of system
control device or interface LOCKED or PROTECTED the specified
output. If the output is not locked or protected, no response will be
sent. The response codes are as follows:
ZJ000: Jupiter Control Panel
ZJ001-004: Party Line Control Panel
ZJ999: THIS ASCII INTERFACE
Note
Lock status returned for the first level only in the
CP Level Set for this ASCII port.