Instruction manual
50 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 2 — Hardware Installation
Installing Redundant CM-4400 Control Modules
In a Redundant CM-4400 system, the redundancy cable between the units
is marked “Master” on one end; whichever Control module is connected to
this end of the cable is always the master unit.
The wiring for a redundant CM-4400 system is shown in Figure12. The
BOP 4000 Break Out Panel is designed to
be mounted in the back of an
equipment rack, behind the redundant CMs.
Figure 12. Redundant CM-4400 Installation
CC−2010 Matrix (Cross-
point bus) cables
House sync required for vertical
interval switching.
Routing
switcher
CM 4400
Redundancy
Cable
House time
code
Crosspoint
bus port
BOP 4400 Break
Out Panel
Hub
10/100baseT
Jupiter LAN
071826105_CM 4400 Installation