Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 63
Encore Control of Jupiter
Hardware Connections
For complete information regarding jumper settings and cabling, refer to
the technical manual supplied with the data switcher.
Software Configuration
Configuration entries are required on the Switcher Description table,
Switcher Input table, Switcher Output table, CP Input Set, and CP Output
Set. For an overview of DM 400B configuration, see Data Switching Applica-
tions on pa
ge 165.
Encore Control of Jupiter
The Encore System Controller Board (SCB) can send switching commands
to a Jupiter control system (Figure 27 on page 64). Jupiter can in turn send
the commands to a Crosspoint Bus router such
as Trinix. The ESswitch Pro-
posed ESbus Routing Switcher Dialect is
used when Encore is controlling
Jupiter.
The ESswitch protocol is selected on the Ser
ial Protocol table; the Encore
SCB is identified as a Serial device on the MPK Devices table. Hardware
connections are the same as those used when Jupiter controls an Encore
system.
In the case of redundant CM-4400 / redundant SCB systems, because both
En
core SCBs send the same command, two CM-4400 ports are defined on
the Serial Protocol table and two SCBs are defined on the MPK Devices
table.
Contact Grass Valley for more information about the ESswitch dialect.