Instruction manual

68 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 2 — Hardware Installation
Figure 30. Example of Sequential Path Finding Connections
Non-sequential Path Finding (Path Finding Using Non-sequential Wiring)
In some cases, especially when adding tie lines to an existing system,
wiring new lines out of sequence may be desirable. Figure 31 on page 69
shows example connections for one level.
The Maximum length that the CC-2010 Matr
ix cable can be, when con-
necting the CM-4400 to the Router, is 50
ft. (15.24 m). Grass Valley recom-
mends installing a separate CM- 4400 System Contr
oller for each switcher
using the CC-2010 Matrix cable.
20 21 22
10
11
12
13
14
43 44 45 46 47
61
62
63
Grass Valley
Crosspoint Bus
distribution switcher
“A”
Grass Valley
Crosspoint Bus
distribution switcher
“B”
CC 2010 Matrix
cable. 50 ft.
(15.2 m) max.
Tie lines can be connected
starting with any input or out-
put but must then follow in
sequential order.
Inputs
Outputs
Inputs
Outputs
CC 2010 Matrix cable.
50 ft. (15.2 m) max.
Hub
10/100baseT
Jupiter LAN
CM 4400 System Controller
Crosspoint Bus port
CM 4400 System Controller
Crosspoint Bus port