Instruction manual

72 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 2 — Hardware Installation
Installing a File Server PC
The minimum hardware and software requirements for the File server are
described in File Server Minimum Specifications on page 279. Follow the
instructions supplied with the file server
for connecting the monitor, key-
board, and mouse.
The Jupiter LAN
Jupiter file servers are connected to the CM-4400 through an IP hub, switch,
or media converter via the Jupiter LAN. Grass valley does not recommend,
nor does it support, connecting non-Jupiter equipment to the Jupiter LAN
other than IP devices such as hubs or switches.
The Jupiter LAN is an IEEE 802.3 10/100BaseT netw
ork using a twisted
pair cable with RJ-45 connectors (Cat 5E Enhanced is recommended).
Shielded cable is also recommended, maximum length 60 meters. Compli-
ance with EEC, EMC, EN series, UL- 19
50, and CSA C22.2 No. 950-M89
standards requires use of a shielded cable. Maximum length for un-
shielded cable is 100 meters.
Figure 33. PC-to-CM Connections
Printers
A printer can be connected to the local file server to print the contents of an
entire Jupiter Configuration Set in a 132-column format. This printer can
also be used to print the contents of the individual Configuration tables (see
Printing on
page 142).
Software Installation
Procedures for installing the Jupiter software on the file server are found in
Software Update on pa
ge 85. The Release notes that are supplied with the
Jupiter software will have Installation instr
uctions as well as any special
instructions for that version of the Jupiter software.
Jupiter File Server
“Remote”
PC
10/100baseT
Jupiter LAN
CM 4400
System
Controller
Hub