Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 83
Section 3
Software Installation
New Jupiter systems ship from the factory with the latest version of soft-
ware pre-installed. New systems do not need their software updated. How-
ever, new Jupiter systems will need to be configured to operate at your
facilit
y. For quick system startup you may wish to refer to the Jupiter Getting
Started Guide. This booklet provides an abbreviated version of the configu-
ration instructions in this
manual and is available on Grass Valley's Web
site.
If the Jupiter software is being upgraded from a previous version, you must
follow the
instructions in the appropriate Grass Valley Release note. Failure
to do so could result in loss of user data. For more information, please
contact Grass Valley Technical Support (see Contacting Grass Valley on page 4
in this manual).
If the software is being installed for the first time, follow the procedure
below
.
Caveats
Please read the following caveats before starting the installation procedure.
During this upgrade or installation procedure:
• Read the Installation instructions befor
e you start the Installation pro-
cess.
• It is recommended that you obtain the required IP address for the
Jupiter system before you start the installation process. See your
Network administrator.
• All switcher status will be lost. To restore status, make note of the status
of all outputs before starting the upgrade and re-take all switches. Or,
you can use Router Save/Restore to restore status on Grass Valley (GV)
routers.
• All memory on all Jupiter control system boards will be cleared after
the installation and download process. The memory is cleared due to a
mandatory “pmemclear“ command.