Instruction manual

JUPITER CM-4400 Control Module Installation and Operating Manual 85

Software Update

CAUTION During the software update your Jupiter system will be taken off-line for a

short time while the control boards (CM-4400) are updated. Existing matrix

cross-points will remain selected, but source to destination changes will not

be possible while the control boards are off-line.

Contact Grass Valley Customer Support if you have any questions

regarding this software update.

Note Read these instructions carefully and follow all the steps exactly to help

ensure that your update goes smoothly.

Updating Existing Jupiter Systems

This procedure is for updating an existing Jupiter system that has been pre-

viously installed, completely configur

ed, and is operating correctly.

It is recommended that you gather the

required IP address for the Jupiter

system before you start the installation process. You will be asked for this

information when you install Jupiter (Figure 52 on page 91).