Instruction manual

86 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 3 — Software Installation
Installing the Jupiter Software Components
Updating a Previous Installation
The update procedure is a two-step process. The first step is Removing the
Previous Version of the Jupiter software. The second step is Installing the
Latest Version of the application.
Each of these steps is described in detail below.
Removing the Previous Version
The Installation program will check to see if an earlier version of Jupiter is
installed on the computer. The earlier version will be removed before the
latest version will be installed. You will need to start the Installation
program again after the earlier version has been removed.
To start the update process and remove the previous version:
1. Insert the Jupiter System Software CD into the PC. If the Installation
Program doesn’t start up automatically, double-click the
Setup.exe icon
on the CD. The Preparing to Install screen will then be displayed
(Figure42).
Figure 42. Preparing to Install Screen